User Manual

EMU Generated Condition Reports

163Enterprise Virtual Array 3000 User Guide

Correcting Errors

Correcting an error may require you to perform a specific set of actions. In some

cases, the only available corrective action is to replace the element.

Table 43 lists the element type codes assigned to the drive enclosure elements.

Elements that do not have an active condition report are shaded.

Drive Conditions

The format of a disk drive condition report is 0.1.en.ec, where:

■ 0.1. is the disk drive element type number

■ en. is the two-character disk drive element

Table 43: Assigned Element Type Codes

Code Element

0.1. Disk Drives (see ““Drive Conditions” on page 163)

0.2. Power Supplies (see Figure 65 on page 167)

0.3. Blowers (see Figure 66 on page 169)

0.4. Temperature Sensors (see Table 44 on page 172)

0.6. Audible Alarm

1. A shaded element does not generate a condition report. However, for any

error, you should record the error code. Then, implement the recommended

corrective action.

0.7. EMU

0.C. Controller OCP LCD

0.F. Transceivers (see Figure 68 on page 181)

1.0. Language

1.1. Communication Port

1.2. Voltage Sensors (see Table 45 on page 182)

1.3. Current Sensors (see Table 45 on page 182)

8.0. Drive Enclosure

8.2. Drive Enclosure Backplane

8.7. I/O Modules (see Figure 69 on page 185)

F.F. Host