Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 1 AAA and RADIUS/HWTACACS Protocol
Configuration Commands
3Com Corporation
1-12
Description
Use the ip pool command to configure a local address pool for assigning addresses to
PPP users.
Use the undo ip pool command to delete the specified local address pool.
By default, no local IP address pool is configured.
You can configure an IP address pool in system view and use the remote address
command in interface view to assign IP addresses from the pool to PPP users.
You can also configure an IP address pool in ISP domain view for assigning IP
addresses to PPP users in the current ISP domain. This applies to the case where an
interface serves a great amount of PPP users but with inadequate address resources
for allocation. For example, an Ethernet interface running PPPoE can accommodate
4095 users at most. However, only one address pool with up to 1024 addresses can be
configured on its Virtual Template (VT). This is obviously far from what is required. To
address the issue, you can configure address pools for ISP domains and assign
addresses from them to their PPP users.
Related command: remote address.
Example
# Configure the local IP address pool 0 with the address range of 129.102.0.1 to
129.102.0.10.
[3Com] domain huawei163.net
[3Com-isp-huawei163.net] ip pool 0 129.102.0.1 129.102.0.10
1.1.11 level
Syntax
level level
undo level
View
Local user view
Parameter
level: Specifies user priority level, an integer ranging from 0 to 3.
Description
Use the level command to configure user priority level.
Use the undo level command to restore the default user priority level.
By default, user priority level is 0.