Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 1 AAA and RADIUS/HWTACACS Protocol
Configuration Commands
3Com Corporation
1-19
[3Com-luser-huawei1] service-type ppp callback-nocheck
1.1.19 state
Syntax
state { active | block }
View
ISP domain view, local user view
Parameter
active: Configured to allow users in the current ISP domain or the current local user to
request for network services.
block: Configured to block users in the current ISP domain or the current local user to
request for network services.
Description
Use the state command to configure the state of the current ISP domain or local user.
By default, both ISP domain (in ISP domain view) and local user (in local user view) are
in the active state upon their creation (in ISP domain view).
Every ISP domain can be active or blocked. If an ISP domain is configured to be active,
the supplicants in it can request for network services; whereas in the block state, its
users are disallowed to request for any network service, which does not affect the users
currently online. This also applies to local users.
Related command: domain.
Example
# Set the state of the current ISP domain "huawei163.net" to block. The supplicants in
this domain cannot request for network services.
[3Com-isp-huawei163.net] state block
# Set the state of the user "huawei1" to block.
[3Com-luser-huawei1] state block
1.2 RADIUS Protocol Configuration Commands
1.2.1 accounting-on
Syntax
accounting-on enable [ send times ] [ interval interval ]
undo accounting-on { enable | send | interval }