Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 1 AAA and RADIUS/HWTACACS Protocol
Configuration Commands
3Com Corporation
1-55
1.3.6 hwtacacs nas-ip
Syntax
hwtacacs nas-ip ip-address
undo hwtacacs nas-ip
View
System view
Parameter
ip-address: Specifies a source IP address.
Description
Use the hwtacacs nas-ip command to specify the source address of the hwtacacs
packet sent from NAS.
Use the undo hwtacacs nas-ip command to restore the default setting.
By specifying the source address of the hwtacacs packet, you can avoid unreachable
packets as returned from the server upon interface failure. The source address is
normally recommended to be a loopback interface address.
By default, the source address is not specified, that is, the address of the interface
sending the packet serves as the source address.
This command specifies only one source address; therefore, the newly configured
source address may overwrite the original one.
Example
# Configure the router to send hwtacacs packets from 129.10.10.1.
[3Com] hwtacacs nas-ip 129.10.10.1
1.3.7 hwtacacs scheme
Syntax
hwtacacs scheme hwtacacs-scheme-name
undo hwtacacs scheme hwtacacs-scheme-name
View
System view
Parameter
hwtacacs-scheme-name: Specifies an HWTACACS server scheme, with a character
string of 1 to 32 characters.