Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 3 HWPing Commands
3Com Corporation
3-15
3.1.20 send-trap
Syntax
send-trap { all | probefailure | testcomplete | testfailure }
undo send-trap { all | probefailure | testcomplete | testfailure }
View
HWPing test group view
Parameter
probefailure: Sends traps after test packet transmission fails.
testcomplete: Sends traps upon completion of the test.
testfailure: Sends traps upon test failures.
all: Sends traps for all the events described above.
Description
Use the send-trap command to configure the type of events that trigger trap sending.
Use the undo send-trap command to cancel the configuration of the event type.
By default, no traps are sent.
Example
# Send traps upon completion of tests.
[Router-administrator-icmp] send-trap testcomplete
3.1.21 sendpacket passroute
Syntax
sendpacket passroute
undo sendpacket passroute
View
HWPing test group view
Parameter
None
Description
Use the sendpacket passroute command to enable routing table bypass.
Use the undo sendpacket passroute command to disable routing table bypass.