Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 1 AAA and RADIUS/HWTACACS Protocol
Configuration Commands
3Com Corporation
1-62
Description
Use the retry stop-accounting command to enable stop-accounting packet
retransmission and configure the maximum number of stop-accounting request
attempts.
Use the undo retry stop-accounting command to restore the default setting.
By default, stop-accounting packet retransmission is enabled and has 100 attempts for
each request.
Related command: reset stop-accounting-buffer, hwtacacs scheme, and display
stop-accounting-buffer.
Example
# Enable stop-accounting packet retransmission and allow up to 50 attempts for each
request.
[3Com] retry stop-accounting 50
1.3.16 secondary accounting
Syntax
secondary accounting ip-address [ port ]
undo secondary accounting
View
HWTACACS view
Parameter
ip-address: IP address of the server, a valid unicast address in dotted decimal format.
port: Port number of the server, which is in the range 1 to 65535 and defaults to 49.
Description
Use the secondary accounting command to configure a secondary TACACS
accounting server.
Use the undo secondary accounting command to delete the configured secondary
TACACS accounting server.
By default, IP address of TACACS accounting server is all zeros.
You are not allowed to assign the same IP address to both primary and secondary
accounting servers.
You can configure only one secondary accounting server in a HWTACACS scheme. If
you repeatedly use this command, the latest configuration replaces the previous one.