Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 1 AAA and RADIUS/HWTACACS Protocol
Configuration Commands
3Com Corporation
1-65
View
HWTACACS view
Parameter
minutes: Ranges from 1 to 255 minutes. By default, the primary server must wait five
minutes before it resumes the active state.
Description
Use the timer quiet command to set the duration that a primary server must wait
before it can resume the active state.
Use the undo timer quiet command to restore the default (five minutes).
Related command: display hwtacac.
Example
# Set the quiet timer for the primary server to ten minutes.
[3Com] hwtacacs scheme test1
[3Com-hwtacacs-test1] timer quiet 10
1.3.20 timer realtime-accounting
Syntax
timer realtime-accounting minutes
undo timer realtime-accounting
View
HWTACACS view
Parameter
minutes: Real-time accounting interval, which is a multiple of 3 in the range 3 to 60
minutes and defaults to 12.
Description
Use the timer realtime-accounting command to configure a real-time accounting
interval.
Use the undo timer realtime-accounting command to restore the default interval.
Real-time accounting interval is necessary for real-time accounting. After an interval
value is set, the NAS transmits the accounting information of online users to the
TACACS accounting server at intervals of this value.
The setting of real-time accounting interval depends somewhat on the performance of
the NAS and the TACACS server: a shorter interval requires higher device performance.