Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 3 HWPing Commands
3Com Corporation
3-16
By default, routing table bypass is disabled.
With routing table bypass, a remote host can bypass the normal routing tables and
send ICMP packets directly to a host on an attached network. If the host is not on a
directly connected network, an error is returned. You can use this function when pinging
a local host on an interface that has no route defined.
Example
# Bypass routing table when sending ICMP packets.
[Router] sendpacket passroute
3.1.22 source-interface
Syntax
source-interface interface-type interface-number
undo source-interface
View
HWPing test group view
Parameter
interface-type: Interface type.
interface-number: Interface number.
Description
Use the source-interface command to configure the source interface in the
transmitted test packets.
Use the undo source-interface command to cancel the configuration.
By default, no source interface is configured for the transmitted test packets.
Example
# Specify Ethernet 1 as the source interface in the transmitted test packet.
[Router-administrator-dhcp] source-interface ethernet 1
3.1.23 source-ip
Syntax
source-ip ip-address
undo source-ip