Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 6 IKE Configuration Commands
3Com Corporation
6-4
Use the undo dh command to restore the Diffie-Hellman group for an IKE proposal to
the default.
By default, group1, that is, 768-bit Diffie-Hellman group is used.
Related command: ike proposal, display ike proposal.
Example
# Specify 768-bit Diffie-Hellman for IKE proposal 10.
[3Com] ike proposal 10
[3Com-ike-proposal-10] dh group1
6.1.5 display ike peer
Syntax
display ike peer [ peer-name ]
View
Any view
Parameter
peer-name: Name of an IKE peer.
Description
Use the display ike peer command to view the configuration about the specified or all
IKE peers.
Example
# Display the configuration about all IKE peers.
[3Com-ike-peer-good] display ike peer
---------------------------
IKE Peer: good
exchange mode: main on phase 1
pre-shared-key:
peer id type: ip
peer ip address: 0.0.0.0 ~ 255.255.255.255
peer name:
nat traversal: disable
---------------------------