Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 6 IKE Configuration Commands
3Com Corporation
6-17
The NAT keepalive interval must be less than the translation timeout of NAT.
By default, NAT keepalive of IKE is disabled.
Example
# Set the NAT keepalive interval to 30 seconds for IKE peers.
[3Com] ike sa nat-keepalive-timer interval 30
6.1.19 local
Syntax
local { multi-subnet | single-subnet }
undo local
View
IKE-peer view
Parameter
multi-subnet: Sets the subnet type to multiple.
single-subnet: Sets the subnet type to single.
Description
Use the local command to configure the subnet type in IKE negotiation.
Use the undo local command to restore the default subnet type. You can use this
command to enable interoperability between the router and a Netscreen device.
The default is single-subnet.
Example
# Set the subnet type in IKE negotiation to multiple.
[Router-ike-peer-xhy] local multi-subnet
6.1.20 local-address
Syntax
local-address ip-address
undo local-address
View
IKE-peer view