Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 6 IKE Configuration Commands
3Com Corporation
6-21
6.1.25 remote-name
Syntax
remote-name name
undo remote-name
View
IKE-peer view
Parameter
name: Specifies a name for the peer in IKE negotiation. It is a string of 1 to 32
characters.
Description
Use the remote-name command to specify a name for the remote GW.
Use the undo remote-name command to remove the remote GW.
If the initiator uses its GW name in IKE negotiation (that is, id-type name is used), it
sends the name to the peer as its identity, whereas the peer uses the username
configured using the remote-name name command to authenticate the initiator. To
pass authentication, this remote name must be the same one configured using the ike
local-name command on the gateway at the initiator end.
Example
# Set the name of the remote GW to citya.
[Router] ike peer new_peer
[Router-ike-peer-new_peer] remote-name citya
6.1.26 reset ike sa
Syntax
reset ike sa [ connection-id ]
View
User view
Parameter
connection-id: Specifies the SA to be deleted. If this parameter is not specified, all the
SAs at phase 1 will be deleted.
Description
Use the reset ike sa command to delete the security tunnel set up by IKE.