Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 1 L2TP Configuration Commands
3Com Corporation
1-11
Syntax
reset l2tp tunnel { remote-name | tunnel-id }
View
User view
Parameter
remote-name: Name of the peer end of the tunnel, a character string with the length
ranging from 1 to 30.
tunnel-id: Local ID of the tunnel.
Description
Use the reset l2tp tunnel command to clear the specified tunnel connection and all
sessions on the tunnel.
The tunnel connection compulsorily disconnected by the reset l2tp tunnel command
can be reestablished again when the remote user calls in again. You may specify tunnel
connections to be disconnected by specifying remote name. If no such tunnel
connections exist, the current tunnel connections will not be affected. If there are
several tunnel connections (with the same name but different IP addresses), all of them
will be cleared. When tunnel-id is specified, only the corresponding tunnel connection
will be disconnected.
Related command: display l2tp tunnel.
Example
# Clear the tunnel connection with the peer name of AS8010.
<Quidway> reset l2tp tunnel AS8010
1.1.15 reset l2tp user
Syntax
reset l2tp user user-name
View
User view
Parameter
user-name: L2TP user name.
Description
Use the reset l2tp user command to disconnect the L2TP connection of the specified
user. When the user calls in, the connection can be set up.