Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 1 Backup Center Configuration Commands
3Com Corporation
1-2
Example
# Set Serial 1/0/0, Serial 0/0/0 and Logic-channel0 to back up interface Serial 3/0/0 and
configure backup load sharing on Serial 3/0/0.
[3Com ] interface serial3/0/0
[3Com -Serial3/0/0] standby interface serial1/0/0 10
[3Com -Serial3/0/0] standby interface serial0/0/0 30
[3Com -Serial3/0/0] standby interface logic-channel0
[3Com -Serial3/0/0] standby threshold 80 50
[3Com -Serial3/0/0] standby timer flow-check 100
[3Com -Serial3/0/0] standby bandwidth 9
# Display statistics about the traffic on the main interfaces participating in backup load
sharing.
[3Com -Serial3/0/0] display standby flow
Interfacename :Serial3/0/0
Flow-interval(s) : 100
LastInOctets : 868168
LastOutOctets : 1818667
InFlow(Octets) : 50070
OutFlow(Octets) : 100088
BandWidth(b/s) :9000
UsedBandWidth(b/s) : 8000
The following table describes the fields of the command.
Table 1-1 Description on the fields of the display standby flow command
Field Description
Flow-interval(s)
Intervals for checking traffic on the main
interface.
LastInOctets
The sum of the octets received on the
main interface until the last check.
LastOutOctets
The sum of the octets sent on the main
interface until the last check.
InFlow(Octets)
The sum of the octets received on the
main interface during the last interval.
OutFlow(Octets)
The sum of the octets sent on the main
interface during the last interval.
BandWidth(b/s) Bandwidth of the main interface.
UsedBandWidth(b/s)
Actual bandwidth of the interface during
the last interval.