Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 1 Backup Center Configuration Commands
3Com Corporation
1-3
1.1.3 display standby state
Syntax
display standby state
View
Any view
Description
Use the display standby state command to view information about the main and
standby interfaces.
The following table describes the information that the command provides and the
possible values.
Table 1-2 Information about the main and standby interfaces
Item Main interface Standby interface
Interface state UP, DOWN UP, DOWN, STANDBY
Standby state
MUP, MUPDELAY, MDOWN,
MDOWNDELAY, MDESERT
UP, UPDELAY, DOWN,
DOWNDELAY,
STANDBY, DESERT
Standby flag
M---MAIN: the interface is a main interface.
S---Standby: the interface is a standby interface.
V---MOVED: the interface or its main interface is removed, or all
standby interfaces of the interface are removed.
U---USED: the interface is in use as a main or standby interface.
D---LOAD: the interface participates in backup load sharing as a
main interface.
P---PULLED: the interface card where this interface is located is
not in place.
G---LOGICCHANNEL: the interface is a logical channel interface.
Pri
Priority of the standby
interface
Load state WAKE, TO-HYPNOTIZE, TO-WAKE, STABLE
Example
# Set Serial 1/0/0, Serial 0/0/0 and Logic-channel 0 to back up Serial 3/0/0, and
configure backup load sharing on Serial 3/0/0.
[3Com ] interface Serial3/0/0
[3Com -Serial3/0/0] standby interface serial1/0/0 10
[3Com -Serial3/0/0] standby interface serial0/0/0 30
[3Com -Serial3/0/0] standby interface logic-channel0