Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 2 VRRP Configuration Commands
3Com Corporation
2-2
Description
Use the display vrrp command to view current configuration and state information
about VRRP.
If the interface name and standby group number are not specified, the state information
about all the standby groups on the router is displayed. If the interface name is
specified, the state information about all the standby groups on the interface is
displayed. If both arguments are specified, the status information about the specified
standby group is displayed.
Example
# Display information about all standby groups on the router.
<3Com > display vrrp
Virtual Ip Ping : Disable
Ethernet1/0/0 | Virtual Router 1
state : Initialize
Virtual IP : 22.2.2.2
Config Priority : 100
Run Priority : 100
Preempt : YES Delay Time : 0
Timer : 1
Auth Type : NONE
GigabitEthernet0/1/0 | Virtual Router 1
state : Initialize
Virtual IP : 1.1.11.1
Config Priority : 100
Run Priority : 100
Preempt : YES Delay Time : 0
Timer : 1
Auth Type : NONE
2.1.3 vrrp authentication-mode
Syntax
vrrp authentication-mode { md5 key | simple key }
undo vrrp authentication-mode
View
Interface view
Parameter