Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 1 DCC Configuration Commands
3Com Corporation
1-2
This command can be applied only on a dialer interface for configuring the dialer
bundle that the interface will use. Furthermore, a dialer interface can only use a dialer
bundle. This command can be used to specify a dialer bundle used by a dialer interface,
no matter what link-protocol, PPP or Frame Relay, runs on the interface.
Related command: dialer bundle-member.
Example
# Configure the interface Dialer1 to use dialer bundle3, in which the interface Serial0 is
included.
[3Com -Dialer1] dialer bundle 3
[3Com -Serial0/0/0] dialer bundle-member 3
1.1.3 dialer bundle-member
Syntax
dialer bundle-member number [ priority priority | max-link max-num | min-link
min-num]
undo dialer bundle-member number
View
Physical interface view
Parameter
number: Dialer bundle number ranging from 1 to 255.
priority: Priority of the physical interface in the dialer bundle, ranges from 1 to 255. The
physical interface with higher priority will be used first. This is an optional parameter. By
default, priority is 1.
max-num: The maximum number of channels that can be used.
min-num: The minimum number of channels that can be used.
Description
Use the dialer bundle-member command to configure a physical interface included in
a dialer bundle in the Resource-Shared DCC application.
Use the undo dialer bundle-member command to remove the physical interface from
the dialer bundle.
By default, the physical interface is not assigned to any dialer bundle.
This command can only be applied to a physical interface, which can be assigned to
multiple dialer bundles.