Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 1 DCC Configuration Commands
3Com Corporation
1-9
 Note:
z If dialer-group command is not configured, DCC will not dial even if dialer number
command is configured.
z When using Resource-Shared DCC, the same dialer number can be configured on
different dialer interfaces at the calling side; but it is not the case at the called side;
otherwise, the call will fail. When using Circular DCC, the same dialer number can
be configured on different dialer interfaces at the calling side, and it is the same to
the called side.
Related command: dialer route.
Example
# Set the dialer number for dialer1 calling the remote end to “11111”.
[3Com ] interface dialer 1
[3Com -Dialer1] dialer number 11111
1.1.11 dialer priority
Syntax
dialer priority priority
undo dialer priority
View
Physical interface view
Parameter
priority: Indicates the priority level for a physical interface which belongs to a dialer
circular group, ranging from 1 to 127. By default, the priority is 1.
Description
Use the dialer priority command to configure a priority for a physical interface in a
dialer circular group in the Circular DCC configuration.
Use the undo dialer priority command to restore the default priority.
This command sets the order in which the available physical interfaces in a dialer
circular group are used. The physical interfaces with higher priority will be used first.
Related command: dialer circular-group.
Example
# Set the priority of Serial 3/0/0 in dialer circular group0 to 5.