Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 1 DCC Configuration Commands
3Com Corporation
1-10
[3Com -Serial3/0/0] dialer circular-group 0
[3Com -Serial3/0/0] dialer priority 5
1.1.12 dialer queue-length
Syntax
dialer queue-length packets
undo dialer queue-length
View
Physical or dialer interface view
Parameter
packets: Indicates the packet numbers buffered on this interface, ranging from 1 to 100.
By default, the value of max-threshold is 30.
Description
Use the dialer queue-length command to configure the number of packets which
comply with the "permit" statement that can be buffered before a link is set up.
Use the undo dialer queue-length command to restore the default number of the
packets that can be buffered.
In the link establishing process, the packets which comply with the "permit" statement
are held in the buffer queue to wait for transmission as soon as the link is set up. The
setting of packets decides the queue length.
Example
# Configure that 10 packets are buffered on Serial1/0/0.
[3Com -Serial1/0/0] dialer queue-length 10
1.1.13 dialer route
Syntax
dialer route protocol next-hop-address [ mask network-mask-length] [ user hostname ]
[ broadcast ] [ dial-number ] [ autodial ] [ logical-channel logic-channel-number ]
[ interface interface-type interface-number ]
undo dialer route protocol next-hop-address [ mask network-mask-length ]
View
Physical or dialer interface view