Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 1 DCC Configuration Commands
3Com Corporation
1-11
Parameter
protocol: Network protocol. At present, it can be IP only.
next-hop-address: Host or network address of the dialed destination.
mask network-mask-length: Optional, mask length of the network address of the dialed
destination, in the range 0 to 32. If no mask length is specified, the default, 32, applies,
where the next-hop-address argument is handled as a host address. If you want to set
the next-hop-address argument to a network address, you must specify its mask
length.
user hostname: Remote user name, which is optionally specified for authentication
implemented when receiving calls. Hostname is a string of 1 to 80 characters.
broadcast: An optional parameter indicating that the broadcast packets can be
transmitted on this link.
dial-number: Dial number of the remote end.
autodial: If this parameter is defined in a dialer route, the router will automatically
attempt to dial according to the dialer route at a certain interval. The interval is set in the
dialer autodial-interval command, which is 300 seconds by default.
logical-channel logic-channel-number: Number of the specified logic channel of the
standby center.
interface interface-type interface-number: Specifies to dial from the specified physical
interface. When multiple physical interfaces are assigned to a dialer interface and their
dial-up links are connected to different ISDN switches, you need to associate dial-up
numbers with physical interfaces. This configuration is intended for dialer interfaces
only and is not available with RS-DCC.
Description
Use the dialer route command to allow a DCC interface to call the specified
destination address (host or network address) or to receive calls from multiple remote
ends.
Use the undo dialer route command to remove a dialer route.
By default, no dialer route is defined.
To originate a call, the parameter dial-number must be configured. If the user keyword
is used, PPP authentication must be configured.
The user can configure multiple dialer routes for a dial port or a destination address.
 Note:
If the dialer-group command is not configured, DCC will not dial.