Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 1 DCC Configuration Commands
3Com Corporation
1-14
Example
# Set the DCC automatic calling interval on Serial0/0/0 to 60 seconds.
[3Com -Serial0/0/0] dialer timer autodial 60
1.1.16 dialer timer compete
Syntax
dialer timer compete seconds
undo dialer timer compete
View
Physical or dialer interface view
Parameter
Seconds: Idle interval when contention occurs, ranges from 0 to 65535 seconds. By
default, the idle interval is 20 seconds.
Description
Use the dialer timer compete command to configure an idle interval for an interface
after call contention occurs on the interface.
Use the undo dialer timer compete command to restore the default interval.
Contention occurs if no free channel is available when DCC tries to originate a call.
Normally, after a link is set up, timer idle timing will take effect. However, if a call to a
different destination address is to be originated on this interface under the contention
circumstances, DCC replaces the timer idle timing with the timer compete timing.
Example
# Set timer idle and timer compete respectively to 50 seconds and 10 seconds on
Serial 0/0/0.
[3Com -Serial0/0/0] dialer timer idle 50
[3Com -Serial0/0/0] dialer timer compete 10
1.1.17 dialer timer enable
Syntax
dialer timer enable seconds
undo dialer timer enable
View
Physical or dialer interface view