Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 1 DCC Configuration Commands
3Com Corporation
1-15
Parameter
seconds: Interval for originating the next call, ranges from 5 to 65535 seconds. By
default, the interval is 5 seconds.
Description
Use the dialer timer enable command to configure an interval for the next call attempt
on an interface after the link is disconnected.
Use the undo dialer timer enable command to restore the default interval.
Example
# Set the interval for DCC to make the next call attempt to 15 seconds.
[3Com -Serial0/0/0] dialer timer enable 15
1.1.18 dialer timer idle
Syntax
dialer timer idle seconds
undo dialer timer idle
View
Physical or dialer interface view
Parameter
seconds: Time that a link is allowed to be idle, ranges from 0 to 65535 seconds. By
default, seconds is 120 seconds.
Description
Use the dialer timer idle command to configure the interval that a link is allowed to be
idle (in other words, the interval when there is no packets which comply with the
“permit” statements transmitted) after a call has been set up on the interface.
Use the undo dialer timer idle command to restore the default duration.
After a link is set up, the timer idle timer will take effect. If no interesting packets are
transmitted on the link within the specified time, DCC will automatically disconnect the
link. If timer idle is set to 0, the link will never be disconnected, regardless of whether
there are no packets, which comply with the “permit” statements, to be transmitted over
the link or not.
Example
# Set the timer idle on the interface Serial 0/0/0 to 50 seconds.
[3Com -Serial0/0/0] dialer timer idle 50