Command Reference Guide

3Com Router 3000 Ethernet Family

Chapter 2 Dynamic Routing Standby

Configuration Commands

3Com Corporation

2-1

Chapter 2 Dynamic Routing Standby

Configuration Commands

2.1.1 standby timer routing-disable

Syntax

standby timer routing-disable seconds

undo standby timer routing-disable

View

Dial interface view

Parameter

seconds: Delay for the dynamic routing standby module to disconnect the secondary

link. It is in the range 1 to 65535 and defaults to 0.

Description

Use the standby timer routing-disable command to specify a delay for the secondary

link to be disconnected after the primary link goes up to avoid route oscillation.

Use the undo standby timer routing-disable command to restore the default delay,

that is, 0.

By default, the secondary link is disconnected immediately.

 Note:

A dial interface refers to a physical dial interface such as PRI and BRI, or a logical dial

interface, that is, dialer interface.

Example

# On the interface BRI 0/0/0 disconnect the secondary link five seconds after the

primary link resumes.

[3Com -Bri0/0/0] standby timer routing-disable 5

# On the interface BRI 0/0/0 disconnect the secondary link immediately after the

primary link resumes.

[3Com -Bri0/0/0] undo standby timer routing-disable