Command Reference Guide

3Com Router 3000 Ethernet Family

Chapter 2 Dynamic Routing Standby

Configuration Commands

3Com Corporation

2-2

2.1.2 standby routing-group

Syntax

standby routing-group group-number

undo standby routing-group group-number

View

Dial interface view

Parameter

group-number: Number of the dynamic routing standby group, ranging from 1 to 255.

Description

Use the standby routing-group command to apply a dynamic routing standby group

on the secondary interface.

Use the undo standby routing-group command to remove the dynamic routing

standby group from the dialer interface.

Before applying a dynamic routing standby group on the interface, make sure you have

successfully configured the legacy DCC.

Example

# Apply dynamic routing standby group 1 on the interface BRI 0/0/0.

[3Com -Bri0/0/0] standby routing-group 1

# Remove dynamic routing standby group 1 from the interface BRI 0/0/0.

[3Com -Bri0/0/0] undo standby routing-group 1

2.1.3 standby routing-rule

Syntax

standby routing-rule group-number ip ip-address ip-mask

undo standby routing-rule group-number [ ip ip-address ip-mask ]

View

System view

Parameter

group-number: Number of the dynamic routing standby group, ranging from 1 to 255.

ip-address: Address of the network segment to be monitored, or the destination

address of the call placed after standby dialup is enabled.

ip-mask: IP address mask.