Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 5 User Interface Configuration Commands
3Com Corporation
5-5
z When the AUX port on your router functions as the console port, you cannot
execute the auto-execute command on it.
z These restrictions do not apply to other types of user interfaces.
When the user logs on from this interface, the system automatically executes the
command configured using the auto-execute command command and disconnects
the user connection after completing execution.
A good example is configuring the auto-execute command telnet command to have
users telnet to the specified host automatically.
Take caution when using this command on a user interface. It disables you to configure
the system on the user interface.
Caution:
Before configuring the auto-execute command command and saving it with the save
command, make sure that means exist that allow you to access the system to remove
the configuration.
Example
# Allow the system to execute the telnet 10.110.100.1 command automatically after a
user logs on from the AUX interface.
[3com-ui-aux0] auto-execute command telnet 10.110.100.1
5.1.6 databits
Syntax
databits { 5 | 6 | 7 | 8 }
undo databits
View
User interface view
Parameter
5: Five data bits.
6: Six data bits.
7: Seven data bits.
8: Eight data bits.