Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 5 User Interface Configuration Commands
3Com Corporation
5-9
Parameter
all: Displays information about users of all user interfaces.
Description
Use the display users command to view the login information of the users on each
user interface.
Example
# Display state about all user interface users.
<3com> display users
UI Delay Type Ipaddress Username Userlevel
+ 0 CON 0 00:00:00 3
130 VTY 0 00:00:05 TEL [phone] tb 2
You can see information on all active terminal lines. The following table describes the
fields in the output.
Table 5-1 Fields in the output of the display users command
Field Description
+ Indicates the terminal line in use.
UI
The first number and the second number
are respectively the absolute index and
relative index of the user interface.
Delay
Interval since the last input, in the format
of hh:mm:ss.
Type
User type, such as Telnet, SSH, and
PAD
Ipaddress
Location where connection is initiated,
or IP address of the call-in host.
Username
Username that the user uses to log in
from this user interface. In this example,
this field is void because AAA
authentication is not required on this
terminal line.
Userlevel
User authority or level: 0 for visit, 1 for
monitor, 2 for system, and 3 for manage.
# Execute the display users all command on the console.
<3com> display users all
UI Delay Type Ipaddress Username Userlevel
+ 0 CON 0 00:00:00 3
129 AUX 0