Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 5 User Interface Configuration Commands
3Com Corporation
5-14
Description
Use the modem or modem both command to allow modem calls to pass through, both
incoming and outgoing.
Use the modem [ call-in | call-out ] command to allow incoming or outgoing modem
calls to pass through.
Use the undo modem or undo modem both command to disable modem calls to
pass through, both incoming and outgoing.
Use the undo modem [ call-in | call-out ] command to disable incoming or outgoing
modem calls to pass through.
By default, both incoming and outgoing modem calls are disabled to pass through.
This command is only available with the AUX interface and other asynchronous
interfaces (TTYs). You cannot use it on the console interface.
Example
# Set the modem call attribute on TTY 1.
[3com-ui-tty1] modem
5.1.17 modem auto-answer
Syntax
modem auto-answer
undo modem auto-answer
View
User interface view
Parameter
None
Description
Use the modem auto-answer command to set the answering mode to auto-answer.
Use the undo modem auto-answer command to restore the default, or manual
answer.
This command applies only to the AUX interface and other TTYs. You cannot use it on
the console interface.
To allow a user interface to accept dial-up connections using modem, you must first set
the modem parameters on it.