Command Reference Guide

3Com Router 3000 Ethernet Family

Error! Reference source not found.Error! Re

erence source not found.

3Com Corporation

9-9

 Note:

You may specify a source IP address for the packets sent by the Telnet server with the

telnet-server source-interface command or with the telnet-server source-ip

command. If both commands are configured, the one configured later overrides.

Example

# Set the source interface for the Telnet server to ethernet0/0/0.

[Router] telnet-server source-interface Ethernet 0/0/0

9.1.14 telnet-server source-ip

Syntax

telnet-server source-ip ip-address

undo telnet-server source-ip

View

System view

Parameter

ip-address: Source IP address.

Description

Use the telnet-server source-ip command to specify a source IP address for the

packets sent by the Telnet server. This IP address must be a local IP address.

Use the undo telnet-server source-ip command to delete the source IP address

specified for the Telnet server. After that, the source IP address of each packet sent by

the Telnet server is the IP address of the interface where the packet is sent out.

By default, the source IP address in each packet sent by the Telnet server is the IP

address of the interface where the packet is sent out.

 Note:

You may specify a source IP address for the packets sent by the Telnet server with the

telnet-server source-interface command or with the telnet-server source-ip

command. If both commands are configured, the one configured later overrides.