Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 1 Interface Management Commands
3Com Corporation
1-5
Table 1-1 Description on the displayed information
Field Description
Serial0 is up Physical layer state of the interface
line protocol is up Link layer state of the interface
5 minutes input rate
The input rate of the interface within the last five
minutes
5 minutes output rate
The output rate of the interface within the last five
minutes
FIFO queueing: FIFO Type of the output queue on the interface
51 packets input, 640 bytes,
0 no buffers
Packets and bytes received by the interface and
the packets discarded due to the unavailability of
receive-buffer.
55 packets output, 700 bytes,
0 no buffers
Packets and bytes sent by the interface and the
packets discarded due to the unavailability of
send-buffer.
input errors:0, CRC:0, frame
errors:0
The received packets that contain errors, including
CRC errors and frame errors.
DCD=UP DTR=UP DSR=UP
RTS=UP CTS=UP
State of the physical electrical signals DCD, DTR,
DSR, RTS, and CTS
1.1.5 display status interface
Syntax
display status interface interface-type interface-number
View
Any view
Parameter
interface-type interface-number: Specifies an interface by its type and number.
Description
Use the display status interface command to display the state of the specified
interface.
Example
# Display the state of Ethernet interface 0/0/0.
[Router] display status interface ethernet 0/0/0
transmit information
call times: 1