Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 2 Fundamental Ethernet Interface
Configuration Commands
3Com Corporation
2-1
Chapter 2 Fundamental Ethernet Interface
Configuration Commands
2.1 Fundamental Ethernet Interface Configuration
Commands
2.1.1 display interface { ethernet | gigabitethernet }
Syntax
display interface { ethernet | gigabitethernet } [ interface-number ]
View
Any view
Parameter
ethernet: Displays the state of FE interfaces.
gigabitethernet: Displays the state of GE interfaces.
interface-number: Interface number. If no interface is specified, the configuration and
state information on all the interfaces is displayed.
Description
Use the display interface { ethernet | gigabitethernet } command to view information
about Ethernet interfaces, such as their configurations and current running state.
Example
# Display state information about Ethernet interface 2/0/0.
<3Com > display interface ethernet 2/0/0
Ethernet2/0/0 current state : UP
Line protocol current state : UP
Description : Ethernet2/0/0 Interface
The Maximum Transmit Unit is 1500, Hold timer is 10(sec)
Internet Address is 172.31.29.103/16
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is
00e0.fc06.3085
Media type is twisted pair, loopback not set, promiscuous mode not set
100Mb/s-speed mode,Full-duplex mode,link type is autonegotiation
Output flow-control is unsupported, input flow-control is unsupported
Output queue : (Urgent queue : Size/Length/Discards) 0/500/0