Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 2 Fundamental Ethernet Interface
Configuration Commands
3Com Corporation
2-3
Field Description
Last 5 minutes input rate 227.13
bytes/sec, 2.67 packets/sec
Last 5 minutes output rate 0.00
bytes/sec, 0.00 packets/sec
Input and output rates within the last five
minutes on the interface, in terms of
bytes per second and packets per
second
Input: 542665 packets, 47721004 bytes
271460 broadcasts, 271205 multicasts
0 errors, 0 runts, 0 giants,
0 CRC, 0 align errors, 0 overruns,
0 dribbles, 0 aborts, 0 no buffers
Statistics about input packets for the
interface, covering number of packets,
number of bytes, number of multicast
packets, and number of errors
# Display the running state and relevant information on the GE interface 1/0/1.
[3Com ] display interface GigabitEthernet 1/0/1
GigabitEthernet1/0/1 current state : DOWN
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is
00e0-fc00-1500
The Maximum Transmit Unit is 1500
Media type is twisted pair, loopback not set
Port hardware type is 1000_BASE_SFP
100Mbps-speed mode, unknown-duplex mode
Link speed type is force link, link duplex type is autonegotiation
Flow-control is not enabled
The Maximum Frame Length is 1500
Broadcast MAX-ratio: 100%
Unicast MAX-ratio: 100%
Multicast MAX-ratio: 100%
Allow jumbo frame to pass
PVID: 1
Mdi type: across
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 1
Last 300 seconds input: 0 packets/sec 0 bytes/sec
Last 300 seconds output: 0 packets/sec 0 bytes/sec
Input(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0 pauses
Input(normal): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0 pauses
Input: 0 input errors, 0 runts, 0 giants, 0 throttles, 0 CRC
0 frame, 0 overruns, 0 aborts, 0 ignored, 0 parity errors
Output(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0 pauses