Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 4 Fundamental Logical Interface
Configuration Commands
3Com Corporation
4-21
4.3.3 display virtual-access
Syntax
display virtual-access { dialer [ number ] | vt [ vt-number ] | user user-name | peer
peer-address | va-number }*
View
Any view
Parameter
dialer number: Dialer interface number.
vt-number: Number of the virtual template to which the virtual access interface is
assigned.
user-name: Login username of virtual access interface.
peer-address: Peer address of the virtual access interface.
va-number: Sequence number of the virtual access interface.
Description
Use the display virtual-access command to view state information about the specified
or all virtual access interfaces.
For VT and dialer interfaces used in MP, PPPoE, and PPPoA, the system may create
virtual access interfaces depending on link state. Thus, to check their link state, you
must use the display virtual-access command.
Example
# Display state information about all virtual access interfaces.
<3Com > display virtual-access vt
Virtual-Template1:0 current state :UP
Line protocol current state :UP
Description : Virtual-Template1:0 Interface
The Maximum Transmit Unit is 1500
Link layer protocol is PPP
LCP opened, MP opened, IPCP opened, OSICP opened
Physical is MP, baudrate: 64000
Output queue : (Urgent queue : Size/Length/Discards) 0/50/0
Output queue : (Protocol queue : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
Last 300 seconds input: 0 bytes/sec 0 packets/sec
Last 300 seconds output: 0 bytes/sec 0 packets/sec
4 packets input, 50 bytes, 0 drops
4 packets output, 50 bytes, 0 drops