Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 1 PPP and MP Configuration Commands
3Com Corporation
1-13
Use the undo ppp mp command to enable the interface to operate in the Single PPP
mode.
By default, the interface encapsulated with PPP operates in the Single PPP mode.
To increase the bandwidth, multiple PPP links can be bound to form a logical MP
interface. For this purpose, it is necessary to specify a virtual-template in system view.
MP can be configured and used only at the physical interfaces which can encapsulate
PPP. To enable MP, you must configure the ppp mp command and the PAP or CHAP
authentication at the physical interface.
Related command: link-protocol ppp, ppp mp user, interface virtual-template.
Example
# Configure the PPP encapsulated interface Serial0/0/0 to work in MP mode.
[3Com-Serial1/0/0] ppp mp
1.1.14 ppp mp mp-group
Syntax
ppp mp mp-group number
undo ppp mp mp-group number
View
Interface view
Parameter
number: MP-group interface number.
Description
Use the ppp mp mp-group command to add the current interface to the specified
MP-group.
Use the undo ppp mp mp-group command to remove the current interface from the
specified MP-group.
Use this command in conjunction with the interface mp-group command to create an
MP-group interface and add an interface to the MP-group. These two tasks are order
independent.
Note that the interfaces added to an MP group must be physical. The logical interfaces
such as tunnel interfaces do not support this command.
Example
# Add serial interface 3/0/0 to MP-group 3.
[3Com] interface serial 3/0/0