Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 3 Bridge Configuration Commands
3Com Corporation
3-1
Chapter 3 Bridge Configuration Commands
3.1 Bridge Configuration Commands
3.1.1 bridge aging-time
Syntax
bridge aging-time seconds
undo bridge aging-time
View
System view
Parameter
seconds: Aging time of the dynamic address table, in the range 10 to 1,000,000
seconds. By default, the aging time of a dynamic address table is 300 seconds.
Description
Use the bridge aging-time command to configure the aging time of the dynamic
address table.
Use the undo bridge aging-time command to restore the default aging time of the
dynamic address table.
Upon the timeout of the timer, the dynamic address entries will be deleted.
Example
# Configure the aging time of the dynamic address table to 500 seconds.
[3Com] bridge aging-time 500
3.1.2 bridge bridge-set enable
Syntax
bridge bridge-set enable
undo bridge bridge-set enable
View
System view