Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 3 Bridge Configuration Commands
3Com Corporation
3-3
3.1.4 bridge enable
Syntax
bridge enable
undo bridge enable
View
System view
Parameter
None
Description
Use the bridge enable command to enable the bridging function.
Use the undo bridge enable command to disable the bridging function.
By default, the bridging function is disabled.
Only after the bridging function is enabled, can the configuration of a bridge be valid.
Example
# Disable the bridging function.
[3Com] undo bridge enable
3.1.5 bridge learning
Syntax
bridge bridge-set learning
undo bridge bridge-set learning
View
System view
Parameter
bridge-set: Bridge set number which the interface belongs to; an integer in the range 1
to 255.
Description
Use the bridge learning command to enable forwarding by dynamic address table.
Use the undo bridge learning command to disable forwarding by dynamic address
table and forward by static address table only.
By default, the dynamic address table is used in forwarding.