Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 3 Bridge Configuration Commands
3Com Corporation
3-5
Example
# Enable the interface Ethernet 0/0/0 to forward the frames with MAC address
0000-0000-0111.
[3Com] bridge 1 mac-address 0000-0000-0111 permit interface ethernet 0/0/0
3.1.7 bridge routing
Syntax
bridge bridge-set routing { ip | ipx }
undo bridge bridge-set routing { ip | ipx }
View
System view
Parameter
bridge-set: Bridge-set number in the range 1 to 255.
ip: IP
ipx: IPX
Description
Use the bridge routing command to enable the routing function of a specified
bridge-set for the specified network protocol.
Use the undo bridge routing command to disable the routing function of the
bridge-set for the specified network protocol.
By default, the routing function is disabled.
When a bridge is configured to route for a particular network protocol, the PDUs of the
protocol are routed if needed.
Example
# Enable IP routing in bridge-set 1.
[Router] bridge 1 routing ip
3.1.8 bridge routing-enable
Syntax
bridge routing-enable
undo bridge routing-enable