Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 3 Bridge Configuration Commands
3Com Corporation
3-6
View
System view
Parameter
None
Description
Use the bridge routing-enable command to enable the routing function of the bridge.
Use the undo bridge routing-enable command to disable the routing function of the
bridge.
By default, the routing function of the bridge is disabled.
The routing function for a protocol can be implemented only when routing is enabled on
the bridge.
Example
# Enable routing on the bridge.
[Router] bridge routing-enable
3.1.9 bridge stp ieee
Syntax
bridge bridge-set stp ieee
undo bridge bridge-set stp ieee
View
System view
Parameter
bridge-set: Number of a bridge set, an integer in the range 1 to 255.
ieee: Ethernet spanning tree protocol (STP).
Description
Use the bridge stp ieee command to specify a bridge set to support IEEE STP.
Use the undo bridge stp ieee command to disable a bridge set to support STP.
The default STP standard supported on a bridge set is IEEE.
STP has multiple standards, which are not compatible. To prevent bridging loops, the
communicating parties must use the same STP standard.