Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 3 Bridge Configuration Commands
3Com Corporation
3-11
# Add interface dialer 0 to bridge set 1.
[3Com] interface Dialer0
[3Com-Dialer0] bridge-set 1
3.1.15 bridge-set stp disable
Syntax
bridge-set bridge-set stp disable
undo bridge-set bridge-set stp disable
View
Interface view
Parameter
bridge-set: Number of a bridge set, in the range 1 to 255.
Description
Use the bridge-set stp disable command to disable STP on the port.
Use the undo bridge-set stp disable command to enable STP on the port.
By default, STP is enabled on the port.
Only after STP is enabled on the port can other STP parameters take effect.
Example
# Disable STP on Ethernet port 0/0/0.
[Router-Ethernet0/0/0] bridge-set 1 stp disable
3.1.16 bridge-set stp port pathcost
Syntax
bridge-set bridge-set stp port pathcost cost
undo bridge-set bridge-set stp port pathcost
View
Interface view
Parameter
bridge-set: Number of a bridge set, in the range 1 to 255.
cost: Path cost of a bridge port, in the range 1 to 65,535. It defaults to 19 if the port is
Ethernet and to 1000 if the port is serial.