Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 3 Bridge Configuration Commands
3Com Corporation
3-16
STP: Fail to send Configuration BPDU.
The transmission of a configuration
BPDU failed.
STP: Fail to send TCN BPDU. The transmission of a TCN BPDU failed.
STP: Received BPDU sent by myself.
A BPDU is received on the port where it
was sent.
STP: Get a wrong port index.
A port index that does not exist is
obtained.
3.1.20 display bridge address-table
Syntax
display bridge address-table [ bridge-set bridge-set | interface interface-type
interface-number | mac mac-address | dlsw ] [ dynamic | static ]
View
Any view
Parameter
bridge-set: Bridge set number, in the range 1 to 255.
interface-type: Interface type.
interface-number: Interface number.
mac-address: MAC address, a group of numbers in hex with the form of
xxxx-xxxx-xxxx.
dlsw: Displays the MAC address table of DLSW.
dynamic: Displays dynamic address entries.
static: Displays static address scanning entries.
Description
Use the display bridge address-table command to view the information of MAC
address forwarding table.
Example
# Display all the static table entries in the address table.
[3Com] display bridge address-table static
# Display the dynamic address entry with MAC address 1-1-1.
[3Com] display bridge address-table mac 1-1-1 dynamic
The information displayed, and to be described in the following table is:
Mac-address Set Flag Aging-time Receive Send Interface-name