Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 3 Bridge Configuration Commands
3Com Corporation
3-18
Bridge module is activated,4 port take part in bridge module at all;
Address table has 0 item, with 0 static one; life cycle is 100 (s).
Bridge set 1:
Configure: bridge ip;
undo bridge ipx;
bridge 1 learning;
interface: Ethernet4/2/0 :up
Ethernet5/2/0 :up
total 2 interface(s) in the set
Bridge set 2:
Configure: bridge ip;
undo bridge ipx;
undo bridge 2 learning ;
interface: Ethernet4/2/0.1 :up
Ethernet5/2/0.1 :up
total 2 interface(s) in the set
From the output information to see that the two bridge sets (bridge sets 1 and 2) are
active. Each comprises configure- and interface-related information.
For description of the information, see:
Table 3-5 Description on the fields of the display bridge information command
Field Description
Configure
This section records the configuration
attributes of the bridge set. For example,
the configure section of bridge set 1 tells
that it can bridge IP packet but not IPX
packet, and can perform dynamic MAC
address learning.
Interface
This section records the interfaces
contained in the bridge set and their
statuses. For example, the interface
section of bridge set 1 tells that there are
two interfaces in bridging: Ethernet4/2/0
and Ethernet5/2/0, both in up status.
Here, UP indicates the activated status
of an interface and DOWN the
inactivated. Only when the interface is in
up status, can a bridge set implement
bridging function.