Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 9 DHCP Configuration Commands
3Com Corporation
9-4
Related command: dhcp select (in interface view).
Example
# Configure the interfaces in the range of Ethernet2/0/0.1 to Ethernet2/0/0.5 to allocate
addresses selected from an interface address pool maintained by the internal server to
the clients sending DHCP packets destined to the local device.
[3Com] dhcp select interface interface ethernet 2/0/0.1 to ethernet 2/0/0.5
9.1.4 dhcp server detect
Syntax
dhcp server detect
undo dhcp server detect
View
System view
Parameter
None
Description
Use the dhcp server detect command to enable pseudo-DHCP-server detection.
Use the undo dhcp server detect command to disable the function.
By default, pseudo-DHCP-server detection is disabled.
If you configure this command on a DHCP client, when receiving a DHCP response
packet from the DHCP server, the client displays information about the DHCP server.
If you configure this command on a DHCP server, when receiving a DHCP request
packet, the server displays the DHCP server information carried by the packet.
Example
# Enable pseudo DHCP server detection.
[3Com] dhcp server detect
9.2 DHCP Server Configuration Commands
9.2.1 accounting domain
Syntax
accounting domain domain-name
undo accounting domain