Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 9 DHCP Configuration Commands
3Com Corporation
9-20
Parameter
ip-address: IP address of NetBIOS server. You can configure up to eight IP addresses
separated by spaces in a command.
all: In the undo form of the command, the first “all” refers to all the NetBIOS server
addresses and the second, all the interfaces.
interface-type interface-number [ to interface-type interface-number ]: Indicates an
interface or all interfaces from the first specified interface to the second. Note that the
interfaces must be Ethernet interfaces (or subinterfaces) or virtual Ethernet interfaces.
Description
Use the dhcp server nbns-list interface command in system view to configure
NetBIOS server addresses for the clients that get ip address from the DHCP address
pool of the interfaces in a specified range.
Use the undo dhcp server nbns-list interface command in system view to delete the
configuration.
By default, no NetBIOS address is configured.
By far, only up to eight NetBIOS addresses can be configured in each DHCP address
pool.
After configuring this command, you cannot view the configuration by executing the
display current-configuration command. By calling the dhcp server nbns-list
command respectively on the specified interfaces, you can fulfill the batch
configurations of the command.
Related command: dhcp server ip-pool, dhcp server nbns-list (in interface view),
nbns-list, and netbios-type.
Example
# In the DHCP address pool of interfaces in the range of Ethernet2/0/0.1 to
Ethernet2/0/0.5, assign the NetBIOS server at 10.12.1.99 to the clients.
[3Com] dhcp server nbns-list 10.12.1.99 interface ethernet 2/0/0.1 to ethernet
2/0/0.5
9.2.18 dhcp server netbios-type (in Interface View)
Syntax
dhcp server netbios-type { b-node | h-node | m-node | p-node }
undo dhcp server netbios-type
View
Ethernet interface (or subinterface) view