Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 12 IP Unicast Policy Routing Configurati
on Commands
3Com Corporation
12-1
Chapter 12 IP Unicast Policy Routing
Configuration Commands
12.1 IP Unicast Policy Routing Configuration Commands
12.1.1 apply default output-interface
Syntax
apply default output-interface interface-type interface-number [ interface-type
interface-number ]
undo apply default output-interface [ interface-type interface-number
[ interface-type interface-number ] ]
View
Route-policy view
Parameter
interface-type: Interface type.
interface-number: Interface number.
Description
Use the apply default output-interface command to set default forwarding interface
for packets.
Use the undo apply default output-interface command to cancel the configuration of
the default forwarding interface of packets.
This command is used to set forwarding interface for the matched IP packet, and the
clause is valid for the packet whose route has not been found.
Use this command to set the next hop where the matched IP packets are to be
forwarded. You can set at most two next hop interfaces.
Related command: apply ip-precedence, apply ip-address next-hop, apply
output-interface, apply ip-address default next-hop.
Example
# Set the default forwarding interface of packets as serial 0/0/0.
[3Com-route-policy] apply default output-interface serial 0/0/0
12.1.2 apply ip-address default next-hop