Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 12 IP Unicast Policy Routing Configurati
on Commands
3Com Corporation
12-2
Syntax
apply ip-address default next-hop ip-address [ ip address ]
undo apply ip-address default next-hop [ ip-address [ ip address ] ]
View
Route-policy view
Parameter
ip-address: IP address of default next hop.
Description
Use the apply ip-address default next-hop command to set the default next hop of a
packet.
Use the undo apply ip-address default next-hop command to cancel the configured
default packet next hop.
This command is only valid for the packet whose route has not been found.
Use this command to set the next hop where the matched IP packets are to be
forwarded. You can set at most two next hop interfaces.
Related command: apply ip-precedence, apply output-interface, apply default
output-interface, and apply ip-address next-hop.
Example
# Set the default next hop of a packet to 1.1.1.1.
[3Com-route-policy] apply ip-address default next-hop 1.1.1.1
12.1.3 apply ip-address next-hop (for Unicast Policy Routing)
Syntax
apply ip-address next-hop ip-address [ ip-address ]
undo apply ip-address next-hop [ ip-address [ ip-address ] ]
View
Route-policy view
Parameter
ip-address: IP address of next hop.
Description
Use the apply ip-address next-hop command to set the packet next hop.