Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 12 IP Unicast Policy Routing Configurati
on Commands
3Com Corporation
12-3
Use the undo apply ip-address next-hop command to cancel the configuration about
the next hop.
This command is used to set the next hop for the matched IP packet and at most two
next hops can be specified. The next hop should be adjacent to this device.
Related command: apply ip-precedence, apply output-interface, apply default
output-interface, apply ip-address default next-hop.
Example
# Set the packet next hop to 1.1.1.1.
[3Com-route-policy] apply ip-address next-hop 1.1.1.1
12.1.4 apply ip-precedence
Syntax
apply ip-precedence value
undo apply ip-precedence
View
Route-policy view
Parameter
value: The preference value. There are totally 8 (in the range 0 to 7) preferences:
0 routine
1 priority
2 immediate
3 flash
4 flash-override
5 critical
6 internet
7 network
Description
Use the apply ip-precedence command to set precedence of IP packets.
Use the undo apply ip-precedence command to remove the precedence of IP
packets.
This command is used to configure the set clause of route-policy and the preference for
the matched IP packets.