Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 12 IP Unicast Policy Routing Configurati
on Commands
3Com Corporation
12-6
Description
Use the display ip policy setup command to view the setting information of policy
routings.
Example
# Display the configurations of policy routing on the specified interface, regardless of
whether the policy routing is enabled.
<3Com> display ip policy setup interface ethernet 0/0/0
route-policy pr01 permit 0
if-match acl 3101
apply output-interface Serial1/0/0
This command displays the configurations of the policy routing named pr01 on
interface Ethernet 0/0/0. As shown above, the policy routing has one 0 node and
includes an if-match clause and an apply clause. For the accurate meanings of the
if-match clause and the apply clause, refer to the description on the command.
The output of the display ip policy setup local command is the same as that of the
display ip policy setup interface command, except that it displays the policy routing
enabled on this router but not the configuration of the specified route-policy.
12.1.8 display ip policy statistic
Syntax
display ip policy statistic { local | interface interface-type interface-number }
View
Any view
Parameter
local: Displays the statistics of local policy routing packets.
interface: Displays the statistics of interface policy routings.
interface-type: Interface type.
interface-number: Interface number.
Description
Use the display ip policy statistic command to view the statistics of policy routings.
Example
# Display statistics about policy routing matches on the specified interface.
<3Com> display ip policy statistic interface ethernet0/0/0
Interface Ethernet0/0/0 policy routing information: