Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 12 IP Unicast Policy Routing Configurati
on Commands
3Com Corporation
12-8
View
Route-policy view
Parameter
min-len: Minimum size of network layer packets, in the range 0 to 2147483647.
max-len: Maximum size of network layer packets, in the range 0 to 2147483647.
Description
Use the if-match packet-length command to set length match conditions of IP
packets.
Use the undo if-match packet-length command to delete the configuration about IP
packet length match conditions.
Related command: if-match acl.
Example
# Set the packet in the range 100 to 200 to be matched.
[3Com] route-policy map1 permit node 10
[3Com-route-policy] if-match packet-length 100 200
12.1.11 ip local policy route-policy
Syntax
ip local policy route-policy policy-name
undo ip local policy route-policy policy-name
View
System view
Parameter
policy-name: Policy name.
Description
Use the ip local policy route-policy command to enable local policy routing.
Use the undo ip local policy route-policy command to delete the existing setting of
the policy routing.
By default, interface local policy routing is disabled.
This command is used to enable or disable the local policy routing for the packets sent
by the local device. If there is no special demand, it is recommended that users do not
configure local policy routing.