Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Error! Reference source not found.Error! Reference source not
found.
3Com Corporation
13-1
Chapter 13 IP Multicast Policy Routing
Configuration Commands
13.1 IP Multicast Policy Routing Configuration Commands
13.1.1 apply ip-address next-hop (for Multicast Policy Routing)
Syntax
apply ip-address next-hop { acl acl-number | ip-address [ ip-address ] }
undo apply ip-address next-hop [ acl acl-number | ip-address [ ip-address ] ]
View
Route-policy view
Parameter
acl-number: Standard ACL number ranging from 2000 to 2999.
ip-address: Specifies the next hop address. Multiple next hop addresses can be
specified.
Description
Use the apply ip-address command to configure the next hop IP address list in a
route-node.
Use the undo apply ip-address command to remove the configuration.
By default, no apply clause is defined.
This command specifies the next hop address for packets that match the if-match acl
command. It specifies the next hop IP address list for multicast policy routing through
the ACL. This command is in juxtaposition relation with the apply output-interface
command. If both apply clauses are configured at the same time, in multicast policy
routing, the packets will be replicated and forwarded to all the interfaces and next hops
specified by the ACLs respectively. This is different from that only one apply clause
works in unicast policy routing.
For the next hop IP address, the specified ACL is the standard ACL.
Related command: if-match acl, apply output-interface, and display ip
multicast-policy.
Example
None