Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Error! Reference source not found.Error! Reference source not
found.
3Com Corporation
13-2
13.1.2 apply output-interface (for Multicast Policy Routing)
Syntax
apply output-interface acl acl-number
undo apply output-interface [ acl acl-number ]
View
Route-policy view
Parameter
acl-number: ID of interface-based ACL, ranging from 1000 to 1999.
Description
Use the apply output-interface command to configure an outgoing interface list in a
route-node.
Use the undo apply output-interface command to remove the configuration.
By default, no apply clause is defined.
This command specifies outgoing interfaces for packets that match the if-match
command. It specifies outgoing interfaces for multicast policy routing through the ACL.
The action executed to packets that meet the if-match conditions defined by the match
clause is as follows: If outgoing forwarding interfaces are set in the route-node through
the ACL, the packets will be replicated and forwarded to all interfaces specified by the
ACL.
For an outgoing interface, the specified ACL is the one based on interface.
This command is in juxtaposition relation with the apply ip-address next-hop
command. If both apply clauses are configured at the same time, in multicast policy
routing, the packets will be replicated and forwarded to all the interfaces and next hops
specified by the ACLs respectively. This is different from that only one apply clause
works in unicast policy routing.
Related command: apply ip-address next-hop, if-match acl, and display ip
multicast-policy.
Example
None
13.1.3 debugging ip multicast-policy
Syntax
debugging ip multicast-policy [ acl-number ]
undo debugging ip multicast-policy