Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 1 Static Route Configuration Commands
3Com Corporation
1-7
verbose: With the parameter, this command displays the verbose information of both
the active and inactive routes that passed filtering rules. Without the parameter, this
command displays the summary of the active routes that passed filtering rules.
Description
Use the display ip routing-table ip-prefix command to view the route that passed the
filtering rule according to the specified ip prefix list.
If there is no specified prefix list, this command will display the verbose information of
all active and inactive routes with the parameter verbose and it will display the
summary of all active routes without the parameter verbose.
Example
# Display the summary of the active route that is filtered through ip prefix list abc2.
<3Com > display ip routing-table ip-prefix abc2
Routes matched by ip-prefix abc2:
Summary count: 4
Destination/Mask Proto Pre Cost Nexthop Interface
127.0.0.0/8 Direct 0 0 127.0.0.1 InLoopBack0
127.0.0.1/32 Direct 0 0 127.0.0.1 InLoopBack0
169.0.0.0/8 Static 60 0 2.1.1.1 LoopBack1
169.0.0.0/15 Static 60 0 2.1.1.1 LoopBack1
# Display the verbose information of the active and inactive routes that are filtered
through ip prefix list abc2.
<3Com > display ip routing-table ip-prefix abc2 verbose
Routes matched by ip-prefix abc2:
Generate Default: no
+ = Active Route, - = Last Active, # = Both * = Next hop in use
Summary count:4
**Destination: 127.0.0.0 Mask: 255.0.0.0
Protocol: #Direct Preference: 0
*NextHop: 127.0.0.1 Interface: 127.0.0.1(InLoopBack0)
Vlinkindex: 0
State: <NoAdvise Int ActiveU Retain Multicast Unicast>
Age: 3:47 Metric: 0/0
**Destination: 127.0.0.1 Mask: 255. 255. 255. 255
Protocol: #Direct Preference: 0
*NextHop: 127.0.0.1 Interface: 127.0.0.1(InLoopBack0)
Vlinkindex: 0
State: <NotInstall NoAdvise Int ActiveU Retain Gateway Multicast Unicast>
Age: 3:47 Metric: 0/0
**Destination: 179.0.0.0 Mask: 255.0.0.0