Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 1 Static Route Configuration Commands
3Com Corporation
1-8
Protocol: #Static Preference:-60
*NextHop: 4.1.1.1
Vlinkindex: 0
State: <Int Hidden Static Unicast>
Age: 3:47 Metric: 0/0
**Destination: 169.0.0.0 Mask: 255.0.0.0
Protocol: #Static Preference: 60
*NextHop: 2.1.1.1 Interface: 2.1.1.1(LoopBack1)
Vlinkindex: 0
State: <Int ActiveU Static Unicast>
Age: 3:47 Metric: 0/0
**Destination: 169.0.0.0 Mask: 255.254.0.0
Protocol: #Static Preference: 60
*NextHop: 2.1.1.1 Interface: 2.1.1.1(LoopBack1)
Vlinkindex: 0
State: <Int ActiveU Static Unicast>
Age: 3:47 Metric: 0/0
1.1.6 display ip routing-table protocol
Syntax
display ip routing-table protocol protocol [ inactive | verbose | vpn-instance
vpn-instance-name]
View
Any view
Parameter
protocol: Has multiple selectable values:
z direct: Displays direct connection route information
z static: Displays static route information.
z bgp: Displays BGP route information.
z isis: Displays IS-IS route information.
z ospf: Displays OSPF route information.
z ospf-ase: Displays OSPF ASE route information.
z ospf-nssa: Displays OSPF NSSA route information.
z rip: Displays RIP route information.
inactive: With the parameter, this command displays the inactive route information.
Without the parameter, this command displays the active and inactive route
information.
verbose: With the verbose parameter, this command displays the verbose routing
information. Without the parameter, this command displays the route summary.